other sections
CP(4) | Device Drivers Manual (i386) | CP(4) |
NAME¶
cp — driver for synchronous Cronyx Tau-PCI WAN adaptersSYNOPSIS¶
To compile this driver into the kernel, place the following line in your kernel configuration file:device cp
Alternatively, to load the driver as a module at boot time, place the following
line in loader.conf(5):
if_cp_load="YES"
device sppp
options NETGRAPH
options NETGRAPH_CRONYX
DESCRIPTION¶
The cp driver needs either sppp(4) or netgraph(4). Which one to use is determined by theNETGRAPH_CRONYX
option. If this option is present in
your kernel configuration file, the cp driver will be
compiled with netgraph(4) support. Otherwise, it will be
compiled with sppp(4) support.
Refer to sconfig(8) for information about the
cp adapter configuration.
HARDWARE¶
The cp driver supports the following models of Tau-PCI WAN adapters:- Cronyx Tau-PCI
- V.35 and RS-232 interfaces
- Cronyx Tau-PCI/R
- RS-530(RS-449) and X.21 interfaces
- Cronyx Tau-PCI-L
- one V.35 and RS-232 interface, low profile
- Cronyx Tau-PCI-L/R
- one RS-530(RS-449) and X.21 interface, low profile
- Cronyx Tau-PCI-E1
- fractional E1 interfaces
- Cronyx Tau-PCI-G703
- unframed E1 interfaces
- Cronyx Tau-PCI-2E1
- fractional E1 and unframed E1 interfaces
- Cronyx Tau-PCI-4E1
- fractional E1 and unframed E1 interfaces
- Cronyx Tau-PCI-E3
- E3 interface
- Cronyx Tau-PCI-T3
- T3 interface
- Cronyx Tau-PCI-STS1
- STS-1 interface
SEE ALSO¶
ctau(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)HISTORY¶
The cp driver was added in FreeBSD 5.3 and FreeBSD 4.11. The cp driver for previous versions of FreeBSD is available from http://www.cronyx.ru/.July 16, 2005 | Debian |