Scroll to navigation

CP(4) Device Drivers Manual (i386) CP(4)

NAME

cpdriver for synchronous Cronyx Tau-PCI WAN adapters

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:

device cp

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_cp_load="YES"

Additional options:
device sppp
options NETGRAPH
options NETGRAPH_CRONYX

DESCRIPTION

The cp driver needs either sppp(4) or netgraph(4). Which one to use is determined by the NETGRAPH_CRONYX option. If this option is present in your kernel configuration file, the cp driver will be compiled with netgraph(4) support. Otherwise, it will be compiled with sppp(4) support.

Refer to sconfig(8) for information about the cp adapter configuration.

HARDWARE

The cp driver supports the following models of Tau-PCI WAN adapters:

Cronyx Tau-PCI
V.35 and RS-232 interfaces
Cronyx Tau-PCI/R
RS-530(RS-449) and X.21 interfaces
Cronyx Tau-PCI-L
one V.35 and RS-232 interface, low profile
Cronyx Tau-PCI-L/R
one RS-530(RS-449) and X.21 interface, low profile
Cronyx Tau-PCI-E1
fractional E1 interfaces
Cronyx Tau-PCI-G703
unframed E1 interfaces
Cronyx Tau-PCI-2E1
fractional E1 and unframed E1 interfaces
Cronyx Tau-PCI-4E1
fractional E1 and unframed E1 interfaces
Cronyx Tau-PCI-E3
E3 interface
Cronyx Tau-PCI-T3
T3 interface
Cronyx Tau-PCI-STS1
STS-1 interface

SEE ALSO

ctau(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)

HISTORY

The cp driver was added in FreeBSD 5.3 and FreeBSD 4.11. The cp driver for previous versions of FreeBSD is available from http://www.cronyx.ru/.

July 16, 2005 Debian