table of contents
other versions
- wheezy 44-11+deb7u4
- wheezy 2.88dsf-41+deb7u1
- wheezy-backports 204-14~bpo70+1
- jessie 215-17+deb8u7
- jessie 2.88dsf-59
- jessie-backports 230-7~bpo8+2
- testing 232-25
- testing 2.88dsf-59.9
- unstable 232-25
- unstable 2.88dsf-59.9
- experimental 233-8
conflicting packages
TELINIT(8) | telinit | TELINIT(8) |
NAME¶
telinit - Change SysV runlevelSYNOPSIS¶
telinit
[OPTIONS...] {COMMAND}
DESCRIPTION¶
telinit may be used to change the SysV system runlevel. Since the concept of SysV runlevels is obsolete the runlevel requests will be transparently translated into systemd unit activation requests.OPTIONS¶
The following options are understood: --helpPrints a short help text and exits.
--no-wall
Don't send wall message before
reboot/halt/power-off.
The following commands are understood:
0
Power-off the machine. This is translated into
an activation request for poweroff.target and is equivalent to systemctl
poweroff.
6
Reboot the machine. This is translated into an
activation request for reboot.target and is equivalent to systemctl
reboot.
2, 3, 4, 5
Change the SysV runlevel. This is translated
into an activation request for runlevel2.target, runlevel3.target, ... and is
equivalent to systemctl isolate runlevel2.target, systemctl isolate
runlevel3.target, ...
1, s, S
Change into system rescue mode. This is
translated into an activation request for rescue.target and is equivalent to
systemctl rescue.
q, Q
Reload daemon configuration. This is
equivalent to systemctl daemon-reload.
u, U
Serialize state, reexecute daemon and
deserialize state again. This is equivalent to systemctl
daemon-reexec.
EXIT STATUS¶
On success 0 is returned, a non-zero failure code otherwise.NOTES¶
This is a legacy command available for compatibility only. It should not be used anymore, as the concept of runlevels is obsolete.SEE ALSO¶
AUTHOR¶
Lennart Poettering <lennart@poettering.net>Developer
10/07/2013 | systemd |