table of contents
NVE(4) | Device Drivers Manual | NVE(4) |
NAME¶
nve — NVIDIA nForce MCP Networking Adapter device driverSYNOPSIS¶
To compile this driver into the kernel, place the following lines in your kernel configuration file:device miibus
device nve
Alternatively, to load the driver as a module at boot time, place the following
line in loader.conf(5):
device nve
if_nve_load="YES"
DESCRIPTION¶
The nve driver provides support for the NVIDIA nForce MCP and nForce2 MCP2 networking adapter that is embedded in the southbridge of most nForce and nForce2 motherboards. This driver is a reimplementation of the NVIDIA supported Linux nvnet driver and uses the same closed source API library to access the underlying hardware. There is currently no programming documentation available for this device, and therefore little is known about the internal architecture of the MAC engine itself. The nve driver supports the following media types:- autoselect
- Enable autoselection of the media type and options.
- 10baseT/UTP
- Set 10Mbps operation.
- 100baseTX
- Set 100Mbps (Fast Ethernet) operation.
- 1000baseTX
- Set 1000Mbps (Gigabit Ethernet) operation.
- full-duplex
- Set full duplex operation.
HARDWARE¶
The nve driver supports the NVIDIA MCP onboard adapters of mainboards with the following chipsets:- nForce
- nForce2
- nForce3
- nForce4
DIAGNOSTICS¶
- nve%d: couldn't map memory
- A fatal initialization error has occurred.
- nve%d: couldn't map interrupt
- A fatal initialization error has occurred.
- nve%d: failed to allocate memory
- There are not enough mbufs available for allocation.
- nve%d: device timeout
- The device has stopped responding to the network, or there is a problem with the network connection (cable).
BUGS¶
There are reports that when the card is in auto select mode, ifconfig output reports a 10baseT/UTP output while the LEDs and bandwidth show that the card is actually in 100baseTX mode.SEE ALSO¶
altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), rgephy(4), ifconfig(8)HISTORY¶
The nve driver first appeared in FreeBSD 6.0.AUTHORS¶
The nve driver was written by Quinton Dolan ⟨q@onthenet.com.au⟩ and David E. O'Brien ⟨obrien@FreeBSD.org⟩.January 16, 2011 | Debian |