other sections
MCD(4) | Device Drivers Manual | MCD(4) |
NAME¶
mcd — Mitsumi CD-ROM driverSYNOPSIS¶
device mcd In /boot/device.hints:hint.mcd.0.at="isa"
hint.mcd.0.port="0x300"
hint.mcd.0.irq="10"
DESCRIPTION¶
The mcd driver provides a data and audio interface to the Mitsumi-brand CD-ROM player. The CD-ROM player must be interfaced to the ISA bus through one of the Mitsumi proprietary controller boards. The controller boards supported are the LU002S, LU005S, the FX001 and the quite common FX001D. The mcd driver responds to disk-specific ioctl() commands, namely theDIOCGDINFO
, DIOCGPART
,
DIOCWDINFO
, and DIOCSDINFO
,
commands. Other disk-specific ioctl() commands will return
an error.
The mcd driver also responds to special CD-ROM
ioctl() commands. These commands control the CD-ROM player's
audio features. The commands are:
- CDIOCREADSUBCHANNEL
- get sub-channel information on current status of disc playing
- CDIOCREADTOCHEADER
- get table of contents header
- CDIOCREADTOCENTRYS
- gets all of the table of contents
- CDIOCPLAYTRACKS
- begins audio playing at location specified
- CDIOCPLAYBLOCKS
- fails with error
EINVAL
- CDIOCPLAYMSF
- begins audio playing at location specified
- CDIOCRESUME
- resumes playing a previously paused disc
- CDIOCPAUSE
- pauses a playing disc
- CDIOCSTART
- begins playing a disc
- CDIOCSTOP
- stops a previously playing disc
- CDIOCEJECT
- opens the disc tray (there is no support for a corresponding un-eject command).
- CDIOCRESET
- stops any play and resets the Mitsumi controller board
- CDIOCSETDEBUG
- cause the kernel to print debug messages to the console about the mcd driver
- CDIOCCLRDEBUG
- cause the kernel to quit printing debug messages about the mcd driver
CDIOCSETVOL
and
CDIOCSETSTERIO
) which are available and may be
supported by future versions of the driver.
FILES¶
- /dev/(r)mcd0a
- accesses BSD partition on the disc. Normally, there is only one file system on a CD-ROM disc.
- /dev/(r)mcd0c
- accesses raw device.
NOTES¶
The character-mode devices for the mcd driver should only be used for accessing the audio features of the CD-ROM player as the performance on data is abysmal. The current version of the driver uses neither the DMA or IRQ features of the interface board, although it has an interrupt handler for any IRQ requests that are generated. Until the DMA features are supported, the only interrupts that the board generates are those that are not supported by the driver anyway.SEE ALSO¶
<sys/cdio.h>HISTORY¶
An mcd driver appeared in FreeBSD 1.0.AUTHORS¶
The driver was written by Holger Veit (data part) and Brian Moore (audio part). Changes were provided by Gary Clark II, Andrew A. Chernov, and Jordan K. Hubbard.December 8, 1994 | Debian |