NAME¶
showkey - examine the scan codes and keycodes sent by the keyboard
SYNOPSIS¶
showkey [ -[hVskm] | --help |
--version | --scancodes | --keycodes
| --keymap ] [ -t N | --timeout=N
]
DESCRIPTION¶
showkey prints to standard output either the scan codes, the keycode, or
the character of each key pressed/released. The program runs until 10 seconds
(or the amount of time specified by the
--timeout or
-t option)
has elapsed since the last key press or release event, or until it receives a
suitable signal, like SIGTERM, from another process.
showkey has three modes of operation, scancode dumping, keycode dumping,
and keymap testing, selected by a command line option (see below).
COMMANDS¶
- -h --help
- showkey prints to the standard error output its
version number, a short usage message, then exits.
- -V --version
- showkey prints to the standard error output its
version number, then exits.
- -s --scancodes
- Starts showkey in scan code dump mode.
In this mode, showkey prints in hexadecimal format each byte received
from the keyboard to the standard output. A new line is printed when an
interval of about 0.1 seconds occurs between the bytes received, or when
the internal receive buffer fills up. This can be used to determine
roughly, what byte sequences the keyboard sends at once on a given key
press. The scan code dumping mode is primarily intended for debugging the
keyboard driver or other low level interfaces. As such it shouldn't be of
much interest to the regular end-user.
- -k --keycodes
- Starts showkey in keycode dump mode. This is the
default, when no command is specified is specified.
In this mode, showkey prints to the standard output the keycode
number or each key pressed or released. The kind of the event, press or
release, is also reported. Keycodes are numbers assigned by the kernel to
each individual physical key. Every key has always only one associated
keycode number, whether the keyboard sends single or multiple scan codes
when pressing it. Using showkey in this mode, you can find out what
numbers to use in your personalized keymap files.
- -m --keymap
- Starts showkey in keycode dump mode.
In this mode, showkey displays the characters as they are translated
by the kernel using the current keymap. It may be useful to writers of
install programs, to allow the user to test a new keyboard before really
installing it.
OPTIONS¶
- -t N --timeout=N
- This option changes the timeout (in seconds) from its
default of 10s.
AUTHOR¶
showkey was developed by Risto Kankkunen for kbd-0.81.
It was later extended by Yann Dirson <dirson@debian.org> to support the
--keymap command and the
--timeout option.
BUGS¶
The
--keymap mode should report action keys by displaying what action
should be performed, instead of executing the action.
SEE ALSO¶
loadkeys(1),
dumpkeys(1),
keymaps(5),
setkeycodes(8).