Scroll to navigation

ZPOOL-REPLACE(8) System Manager's Manual ZPOOL-REPLACE(8)

NAME

zpool-replaceReplace one device with another in a ZFS storage pool

SYNOPSIS

zpool replace [-fsw] [-o property=value] pool device [new_device]

DESCRIPTION

zpool replace [-fsw] [-o property=value] pool device [new_device]
Replaces old_device with new_device. This is equivalent to attaching new_device, waiting for it to resilver, and then detaching old_device. Any in progress scrub will be cancelled.

The size of new_device must be greater than or equal to the minimum size of all the devices in a mirror or raidz configuration.

new_device is required if the pool is not redundant. If new_device is not specified, it defaults to old_device. This form of replacement is useful after an existing disk has failed and has been physically replaced. In this case, the new disk may have the same /dev path as the old device, even though it is actually a different disk. ZFS recognizes this.

Forces use of new_device, even if it appears to be in use. Not all devices can be overridden in this manner.
property=value
Sets the given pool properties. See the zpoolprops(8) manual page for a list of valid properties that can be set. The only property supported at the moment is .
The new_device is reconstructed sequentially to restore redundancy as quickly as possible. Checksums are not verfied during sequential reconstruction so a scrub is started when the resilver completes. Sequential reconstruction is not supported for raidz configurations.
Waits until the replacement has completed before returning.

SEE ALSO

zpool-detach(8), zpool-initialize(8), zpool-online(8), zpool-resilver(8)

May 15, 2020 Linux