table of contents
|Pamgetcolor User Manual(1)||General Commands Manual||Pamgetcolor User Manual(1)|
pamgetcolor - display the average colors from specified regions in an image.
pamgetcolor [-format format] [-radius radius] [-linear] [-infile pamfile] region1 [region2 ...]
This program is part of Netpbm(1).
pamgetcolor prints the average colors of a set of circular regions in the input image.
You specify a region as a positional argument of the form column,row[:label], where column and row are the coordinates of the center of the circle (first row of pixels is row 0; leftmost column of pixels is column 0), and label an optional label that pamgetcolor shall display to identify that region in its output. All regions have he same radius, specified by the -radius option. The region centers must lie within the image, but part of a region may fall outside the image; pamgetcolor considers only the part that is within the image in calculations.
To read the color of the pixel at location (10,14) in the default format:
pamgetcolor 10,14 -infile test.ppm
To read the colors of three pixels in the default format, assigning a label to each pixel:
pamgetcolor 10,10:topleft 100,100:middle 200,200:bottomright -infile test.ppm
To read with 16-bit precision the average color in the circle with a radius of four pixels and the center at (100,100):
pamgetcolor -format int:65535 -radius 4 100,100 -infile test.ppm
In addition to the options common to all programs based on
libnetpbm (most notably -quiet, see
Common Options ), pamgetcolor recognizes the following command line options:
- This specifies the format in which to output the colors. The output is
always a Netpbm color
specification ; this format tells which of the various specifications
for the same color the program uses.
This argument is of the form formatId[:param], where formatId specifies the format and param is a positive integer parameter that, depending on formatId, indicates either precision or normalization. The following values are possible for formatId:
- Samples are decimal integers normalized to the maxval specified by param. Example: rgb-255:255/128/64 This format is the default, with a maxval of 255.
- Samples are floating point numbers normalized to unity. E.g. rgbi:1.0/0.5/.25 param specifies precision as the number of digits in the fractional part.
- Samples are hexadecimal numbers with param digits, e.g. rgb:01/ff/8000
- sets the radius of the regions. A value of zero causes pamgetcolor to measure a single pixel and is the default.
- This specifies the Netpbm file to analyze.
If you don't specify this option, pamgetcolor reads the image from Standard Input.
- This tells pamgetcolor to work with the intensity-linear variation of Netpbm images where the samples are proportional to light intensity rather than to brightness, as in true (gamma-adjusted) Netpbm formats.
This program was first submitted by Anton Shepelev (firstname.lastname@example.org).
This program was new in Netpbm 10.83 (June 2018).
Table Of Contents¶
This manual page was generated by the Netpbm tool 'makeman' from HTML source. The master documentation is at
|18 May 2018||netpbm documentation|