|UEP(4)||Device Drivers Manual||UEP(4)|
uep — eGalax
To compile this driver into the kernel, place the following lines into your kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
To compile this driver with evdev support enabled, place the following lines into the kernel configuration file:
uep driver provides support for the
eGalax onscreen touch panels.
The driver is a stub. It just probes and attaches to USB device, creates a device entry and feeds reassembled packets from the hardware to it. Depending on compile-time kernel options it supports either native or evdev operation modes.
To get the mouse working in X(7) in native mode, install ports/x11-drivers/xf86-input-egalax.
To get the mouse working in X(7) in evdev mode, install ports/x11-drivers/xf86-input-evdev.
uep creates a blocking pseudo-device file,
/dev/uep0 in native mode or
/dev/input/eventN in evdev mode.
usb(4), loader.conf(5), xorg.conf(5) (ports/x11/xorg), egalax(4) (ports/x11-drivers/xf86-input-egalax), evdev(4) (ports/x11-drivers/xf86-input-evdev).
uep driver was written by
uep cannot act like
sysmouse(4), as sysmouse(4) does not
support absolute motion events.
|August 5, 2018||Debian|