table of contents
VERGA(1) | General Commands Manual | VERGA(1) |
NAME¶
verga - VERrilog simulator for tkGAteSYNOPSIS¶
verga [-eslqi] [-d dtype] [-S script] [-P mods] [-t mod] [-B dir] [-D hash] [-W wmode] [files...]DESCRIPTION¶
Verga is a verilog simulator designed to be used with tkgate, but it can also be used as a stand-alone simulator.Verga documentation can be found at:
OPTIONS¶
The options are as follows:- -e
- Dump the list of error codes and associated messages that can be produced by verga. This option is primarily for developer purposes.
- -s
- Scan a Verilog file and output information about its modules and nets. This option is primarily used internally by tkgate.
- -l
- Show the verga license.
- -q
- Run in 'quiet' mode, suppressing extraneous messages.
- -i
- Run in 'interactive' mode. This mode is intended primarily for use when verga is being invoked by tkgate.
- -d dtype
- Type of delays to use. Can be 'min', 'max' or 'typical'.
- -S script
- Load simulation scripts for each '-S' switch.
- -P mod
- Print the named module from the parsed structure for each '-P' specified.
- -t mod
- Override the default and designate 'mod' as the top-level module.
- -B dir
- Directory to use as base directory when loading files
- -D hash
- Delete the input files after loading if 'hash' exactly matches a hash code computed on the file name. This option should only be used by tkgate which writes the file to simulate to a temporary file before invoking the simulator.
- -W wmode
- Mode for warning message handling. Can be 1 for "ignore warnings", 2 for "report warnings only if there were errors", 3 for "always report warnings" or 4 for "always report warnings and stop simulator even if only warnings".