table of contents
- stretch 1:3.3.9-5
AMTAPE(8) | System Administration Commands | AMTAPE(8) |
NAME¶
amtape - Control Amanda changersSYNOPSIS¶
amtape [-o configoption...] config subcommand [subcommand_options...]
DESCRIPTION¶
Amtape is the command-line interface to Amanda's tape changers (amanda-changers(7)) and to the taperscan algorithm (amanda-taperscan(7)).Tape changers maintain a notion of the current slot for each configuration. This may or may not correspond to an actual physical state of the device, but is used by some taperscan algorithms to minimize searching through the slots.
Amtape uses the default changer. To use a different changer, use the config override option, e.g., -otpchanger=otherchanger.
SUBCOMMANDS¶
label labelslot slot
current
inventory
show [slots]
reset
eject [drive]
clean [drive]
taper
update [what]
verify
-o configoption
SEE ALSO¶
amanda(8), amanda-changers(7), amanda-taperscan(7), amanda-devices(7)The Amanda Wiki: : http://wiki.zmanda.com/
AUTHORS¶
Dustin J. Mitchell <dustin@zmanda.com>James da Silva <jds@amanda.org>
Stefan G. Weichinger <sgw@amanda.org>
02/09/2016 | Amanda 3.3.9 |