NAME¶
wicd-manager-settings.conf - contains settings that control Wicd's behavior
DESCRIPTION¶
This file contains general configuration information for Wicd.
This file is located at /etc/wicd/manager-settings.conf
SETTINGS¶
- link_detect_tool = <0|1|2>
- 0 = autodetect
1 = ethtool
2 = mii-tool
- flush_tool = <0|1|2>
- 0 = autodetect
1 = ip
2 = route
- backend = <ioctl|external>
- Default is ioctl backend.
- signal_display_type = <0|1>
- 0 = Show signal strength as a percentage
1 = Show signal strength in dBm
- dhcp_client = <0|1|2|3>
- 0 = autodetect
1 = dhclient
2 = dhcpcd
3 = pump
- sudo_app = <0|1|2|3>
- 0 = autodetect
1 = gksu
2 = kdesu
3 = ktsuss
- wired_interface = <interface_name>
- always_show_wired_interface = <True|False>
- wired_connect_mode = <0|1>
- 0 = connect to wired interface automatically
1 = do not connect to wired interface automatically
- prefer_wired = <True|False>
- True = Switch to wired interface if a link is detected, even if already
connected to wireless
False = Do not switch to wired interface automatically
- wireless_interface = <name_of_wireless_interface>
- wpa_driver =
<wext|madwifi|ndiswrapper|hostap|hermes|atmel|broadcom|ipw|ralinklegacy>
- The default (and best supported) is wext. It should work properly in most
cases.
- auto_reconnect = <True|False>
- This settings determines whether Wicd will attempt to reconnect on
connection loss.
- use_global_dns = <True|False>
- If set to "True" and values are specified in the global DNS
settings below, this will cause Wicd to use these DNS settings.
- global_dns_dom = <plaintext_domain_name>
- This specifies the default search domain to be used by the resolver.
- global_dns_1 = <ip_address>
- global_dns_2 = <ip_address>
- global_dns_3 = <ip_address>
- debug_mode = <integer_value>
- 0 = disabled
1 = enabled
SEE ALSO¶
wicd(8),
wicd-curses(8),
wicd-wired-settings.conf(5),
wicd-wireless-settings.conf(5).