table of contents
other versions
- jessie 215-17+deb8u7
- jessie 2.88dsf-59
- jessie-backports 230-7~bpo8+2
- stretch 232-25+deb9u8
- stretch 2.88dsf-59.9
- testing 240-6
- testing 2.93-8
- stretch-backports 239-12~bpo9+1
- unstable 2.93-8
- unstable 241-1
- experimental 2.94-1
other sections
conflicting packages
HALT(8) | Linux System Administrator's Manual | HALT(8) |
NAME¶
halt, reboot, poweroff - stop the system.SYNOPSIS¶
/sbin/halt [-n] [-w] [-d] [-f] [-i] [-p] [-h]DESCRIPTION¶
halt notes that the system is being brought down in the file /var/log/wtmp, and then either tells the kernel to halt, reboot or power-off the system. If halt or reboot is called when the system is not in runlevel 0 or 6, in other words when it's running normally, shutdown will be invoked instead (with the -h or -r flag). For more info see the shutdown(8) manpage. The rest of this manpage describes the behaviour in runlevels 0 and 6, that is when the systems shutdown scripts are being run.OPTIONS¶
- -n
- Don't sync before reboot or halt. Note that the kernel and storage drivers may still sync. This implies -d.
- -w
- Don't actually reboot or halt but only write the wtmp record (in the /var/log/wtmp file).
- -d
- Don't write the wtmp record.
- -f
- Force halt or reboot, don't call shutdown(8).
- -i
- Shut down all network interfaces just before halt or reboot.
- -h
- Put all hard drives on the system in stand-by mode just before halt or power-off.
- -p
- When halting the system, switch off the power. This is the default when halt is called as poweroff.
DIAGNOSTICS¶
If you're not the superuser, you will get the message `must be superuser'.NOTES¶
Under older sysvinit releases , reboot and halt should never be called directly. From release 2.74 on halt and reboot invoke shutdown(8) if the system is not in runlevel 0 or 6. This means that if halt or reboot cannot find out the current runlevel (for example, when /var/run/utmp hasn't been initialized correctly) shutdown will be called, which might not be what you want. Use the -f flag if you want to do a hard halt or reboot. The -h flag puts all hard disks in standby mode just before halt or power-off. Right now this is only implemented for IDE drives. A side effect of putting the drive in stand-by mode is that the write cache on the disk is flushed. This is important for IDE drives, since the kernel doesn't flush the write cache itself before power-off. The halt program uses /proc/ide/hd* to find all IDE disk devices, which means that /proc needs to be mounted when halt or poweroff is called or the -h switch will do nothing.AUTHOR¶
Miquel van Smoorenburg, miquels@cistron.nlSEE ALSO¶
shutdown(8), init(8)November 6, 2001 |