NAME¶
msh2geo - convert gmsh mesh in geo format
SYNOPSIS¶
msh2geo [-zr|-rz] input[.msh] > output.geo
DESCRIPTION¶
Convert a gmsh `
.msh' into `
.geo' one. The output goes to
standart output. See the
gmsh documentation for a detailed description
of the `
.mshcad' input file for
gmsh.
EXAMPLES¶
gmsh -2 toto.mshcad -o toto.msh
msh2geo toto.msh > toto.geo
gmsh -2 -order 2 toto.mshcad -o toto2.msh
msh2geo toto2.msh > toto2.geo
COORDINATE SYSTEM OPTION¶
Most of rheolef codes are coordinate-system independant. The coordinate system
is specified in the geometry file `
.geo'.
- -zr
- -rz
- the 2d mesh is axisymmetric: zr (resp. rz) stands when the
symmetry is related to the first (resp. second) coordinate.
NOTES¶
Pk triangle, when k>=5, may have internal nodes renumbered: from the
GMSH DOCUMENTATION¶
The nodes of a curved element are numbered in the following order:
the element principal vertices;
the internal nodes for each edge;
the internal nodes for each face;
the volume internal nodes.
The numbering for face and volume internal nodes is recursive,
i.e., the numbering follows that of the nodes of an embedded face/volume.
The higher order nodes are assumed to be equispaced on the element.
In rheolef, internal triangle nodes are numbered from left to right and then
from bottom to top. The numbering differ for triangle when k >= 5. Thus,
msh2geo fix the corresponding internal nodes numbering during the
conversion.
Pk tetrahedrons and hexaedrons in gmsh and rheolef has not the same edge-node
order nd orientation. E.g. for tetrahedrons, edges 13 and 23 should be swaped
and reoriented as 32 and 31. Thus,
msh2geo fix the corresponding
internal nodes numbering.
TODO¶
Fix for P3-tetra: swap edges orientations for 3,4,5 and swap faces 1 and 2.
Check P4(T) for face orientation. Perform face visualisation with gnuplot face
fill.
See also hexa edges orient and faces numbers and orient.
Check that node are numbered by vertex-node, then edge-node, then
face(tri,qua)-node and then volume(T,P,H)-node. Otherwise, renumber all nodes.
Support for high order >= 6 element ? not documented in gmsh, but gmsh
supports it at run