NAME¶
sane-dc210 - SANE backend for Kodak DC210 Digital Camera
DESCRIPTION¶
The
sane-dc210 library implements a SANE (Scanner Access Now Easy)
backend that provides access to the Kodak DC210 camera. THIS IS EXTREMELY
ALPHA CODE! USE AT YOUR OWN RISK!!
DEVICE NAMES¶
The current version of the backend only allows one camera to be connected. The
device name is always "0".
CONFIGURATION¶
The contents of the
dc210.conf specify the serial port and baud rate to
use. The baud rate specifies the maximum rate to use while downloading
pictures. (The camera is always initialized using 9600 baud, then switches to
the higher rate). On my 90MHz Pentium, I usually have no problems downloading
at 115200 baud as long as the system is not excessively busy and the
"interrupt-unmask flag" is set in the IDE driver (hdparm -u1).
Supported baud rates are: 9600, 19200, 38400, 57600, and 115200.
The dumpinquiry line causes some information about the camera to be printed.
cmdrespause specifies how many usec (1,000,000ths of a) between writing the
command and reading the result should be used. 125000 seems to be the lowest I
could go reliably.
breakpause is the time in 1,000,000ths of a usec between sending the "back
to default" break sending commands.
Empty lines and lines starting with a hash mark (#) are ignored. A sample
configuration file is shown below:
port=/dev/ttyS0
# this is a comment
baud=115200
dumpinquiry
cmdrespause=125000
breakpause=1000000
FILES¶
- /etc/sane.d/dc210.conf
- The backend configuration file (see also description of
SANE_CONFIG_DIR below).
- /usr/lib/arch_triplet/sane/libsane-dc210.a
- The static library implementing this backend.
- /usr/lib/arch_triplet/sane/libsane-dc210.so
- The shared library implementing this backend (present on systems that
support dynamic loading).
ENVIRONMENT¶
- SANE_CONFIG_DIR
- This environment variable specifies the list of directories that may
contain the configuration file. Under UNIX, the directories are separated
by a colon (`:'), under OS/2, they are separated by a semi-colon (`;'). If
this variable is not set, the configuration file is searched in two
default directories: first, the current working directory (".")
and then in /etc/sane.d. If the value of the environment variable ends
with the directory separator character, then the default directories are
searched after the explicitly specified directories. For example, setting
SANE_CONFIG_DIR to "/tmp/config:" would result in
directories "tmp/config", ".", and
"/etc/sane.d" being searched (in this order).
- SANE_DEBUG_DC210
- If the library was compiled with debugging support enabled, this
environment variable controls the debug level for this backend. A value of
128 requests maximally copious debug output; smaller levels reduce
verbosity.
SEE ALSO¶
sane(7)
AUTHOR¶
Brian J. Murrell
This backend is based somewhat on the dc25 backend included in this package by
Peter Fales.
The manpage was copied from the dc25 backend and somewhat edited by Henning
Meier-Geinitz.
BUGS¶
Known bugs/limitations are: ?
More general comments, suggestions, and inquiries about frontends or SANE should
go to the SANE Developers mailing list (see
http://www.sane-project.org/mailing-lists.html for details). You must be
subscribed to the list, otherwise your mail won't be sent to the
subscribers.