NAME¶
ladvd - send link layer advertisements
SYNOPSIS¶
ladvd [ -a ] [ INTERFACE ] [ INTERFACE
] ...
DESCRIPTION¶
ladvd sends LLDP (Link Layer Discovery Protocol) advertisements on all
available interfaces. This makes connected hosts visible on managed switches.
By default it will run as a privilege-separated daemon. Additional protocols
can be enabled using the -C, -E, -F and -N options. Optionally a list of
interfaces which
ladvd should utilize can be supplied.
INTERFACES¶
ladvd detects and uses all configured (UP) physical Ethernet interfaces
by default, wireless interfaces can be enabled via the -w option. Additionally
ladvd will recognize bundled interfaces (bridges, bonding) and use
these to transmit additional information. The result is that normally it
should not be necessary to specify interfaces on the
ladvd
command-line. The only reason for specifying interfaces is to explicitly
exclude a particular interface.
OPTIONS¶
- -a
- Auto-enable protocols based on received packets (also enables receive
mode).
- -d
- Dump pcap-compatible packets to stdout which can be piped to tcpdump (via
"| tcpdump -r -") or redirected to a file for further
analysis.
- -f
- Run in the foreground and send logging to stderr.
- -h
- Print usage instructions.
- -m address
- Management address for unnumbered interfaces, can be specified for IPv4
and IPv6.
- -n
- Use management addresses specified via -m for all interfaces.
- -o
- Run only once, useful for quick troubleshooting.
- -r
- Receive packets, and use them for various features.
- -q
- Use each interface's hwaddr the generate the chassis-id TLV. Not
recommended because the chassis-id should be the same for all
interfaces.
- -t
- Use Tun/Tap interfaces.
- -u user
- Switch to this user (defaults to ladvd)
- -v
- Increase logging verbosity.
- -w
- Use wireless interfaces.
- -z
- Save received peer information in interface descriptions (requires
SIOCSIFDESCR support). This also enables receive mode.
- -c <CC>
- Specify a two-letter ISO 3166 country code (required for LLDP location
support).
- -l <location>
- Specify the physical location of the host.
- -C
- Enable CDP (Cisco Discovery Protocol).
- -E
- Enable EDP (Extreme Discovery Protocol).
- -F
- Enable FDP (Foundry Discovery Protocol).
- -N
- Enable NDP (Nortel Discovery Protocol) formerly called SynOptics Network
Management Protocol (SONMP).
AUTHOR¶
Sten Spans <sten@blinkenlights.nl>