generic Ethernet interface netgraph node type
netgraph node implements the generic
Ethernet interface. When eiface
created, a new interface appears which is accessible via
. These interfaces are named
”, etc. When a node is shut down,
the corresponding interface is removed, and the interface name becomes
available for reuse by future eiface
New nodes always take the first unused interface.
node has a single hook named
, which should be connected to the
Ethernet downstream, for example, to the
node. Packets transmitted via the
interface flow out this hook. Similarly, packets received on the hook go to
the protocol stack as packets received by any real Ethernet interface.
This node type supports the generic control messages, plus the following:
- Set link-level address of the interface. Requires
struct ether_addr as an argument. This
message also has an ASCII version, called
set”, which requires as an argument
an ASCII string consisting of 6 colon-separated hex digits.
- Return the name of the associated interface as a
NUL-terminated ASCII string.
- Return the list of link-level addresses associated with the node.
This node shuts down upon receipt of a
control message. The
associated interface is removed and its name becomes available for reuse by
Unlike most other node types, an eiface
go away when all hooks have been
disconnected; rather, and explicit
control message is required.
node type was implemented in
node type was written by
Vitaly V Belekhov
. This manual page was
written by Gleb Smirnoff