NAME¶
kissparms - Configure KISS TNCs.
SYNOPSIS¶
kissparms [-c crc-type] -p <port> [-f y|n] [-h hw] [-l txtail] [-r
pers] [-s slot] [-t txd] [-e feclevel] [-v] [-x] [-X raw]
DESCRIPTION¶
Kissparms is used to dynamically configure KISS TNCs that have been setup
for AX.25 use by
kissattach. This program uses the packet interface to
allow it to communicate with the KISS TNC without interrupting the AX.25 data
stream. Therefore the KISS parameters may be set at any time during the
operation of the AX.25 port.
A full description of the KISS protocol can be found in the ARRL 6th Computer
Networking Conference papers pp 38-43. While use of the Tx Tail value is now
deprecated, it has been included to satisfy the requirements of users of old
TNC firmware.
Although this utility was originally designed for controlling KISS TNCs
connected to a serial port, it is used by a number of other Linux packet radio
devices such as the Z8530 SCC driver for controlling their parameters in
exactly the same manner. Therefore
kissparms functionality extends to
more than KISS TNCs.
OPTIONS¶
- -c crc-type
- Sets the crc-type to use. For e.g. kernel mkiss: 0 = auto, 1 = none, 2 =
flexnet, 3 = smack
- -p port
- Sets the port that is being configured.
- -f y|n
- This sets the TNC into either full duplex ``y'', or half duplex ``n''
mode.
- -h hardware
- This is used to set hardware specific parameters.
- -e FEC error correction level
- Sets the FEC error correction level in a DSP card based modem (KISS
parameter 8). Larger correction level means better noise resistance, but
slower throughput on a good connection. This is an experimental feature
found in a QPSK modem for the Motorola DSP56001 based DSP4 and EVM cards
only.
- -l txtail
- Sets the TX Tail time in milliseconds. Note that the command to the TNC
only operates in steps of ten milliseconds, so only use values like 10, 20
etc.
- -r persist
- Sets the persist value. This parameter is scaled to the range 0 to
255.
- -s slottime
- Sets the slottime in milliseconds. Note that the command to the TNC only
operates in steps of ten milliseconds, so only use values like 10, 20
etc.
- -t txdelay
- Sets the TX Delay in milliseconds. Note that the command to the TNC only
operates in steps of ten milliseconds, so only use values like 10, 20
etc.
- -v
- Display the version.
- -x
- Takes the TNC out of KISS mode back into ``normal'' mode. This command is
manufacturer specific but works in many cases. This option overrides all
options except the port number.
- -Xraw
- Sends the specified raw value to the kiss driver.
SEE ALSO¶
axports(5),
kissattach(8).
AUTHOR¶
Jonathan Naylor G4KLX <g4klx@g4klx.demon.co.uk>