table of contents
other versions
- jessie 3.74-1
- jessie-backports 4.10-2~bpo8+1
- stretch 4.10-2
- testing 4.16-1
- stretch-backports 4.16-1~bpo9+1
- unstable 4.16-1
MEM(4) | Linux Programmer's Manual | MEM(4) |
NAME¶
mem, kmem, port - system memory, kernel memory and system portsDESCRIPTION¶
/dev/mem is a character device file that is an image of the main memory of the computer. It may be used, for example, to examine (and even patch) the system. Byte addresses in /dev/mem are interpreted as physical memory addresses. References to nonexistent locations cause errors to be returned. Examining and patching is likely to lead to unexpected results when read-only or write-only bits are present. Since Linux 2.6.26, and depending on the architecture, the CONFIG_STRICT_DEVMEM kernel configuration option limits the areas which can be accessed through this file. For example: on x86, RAM access is not allowed but accessing memory-mapped PCI regions is. It is typically created by:
mknod -m 660 /dev/mem c 1 1
chown root:kmem /dev/mem
The file /dev/kmem is the same as /dev/mem, except that the kernel
virtual memory rather than physical memory is accessed. Since Linux 2.6.26,
this file is available only if the CONFIG_DEVKMEM kernel configuration
option is enabled.
It is typically created by:
mknod -m 640 /dev/kmem c 1 2
chown root:kmem /dev/kmem
/dev/port is similar to /dev/mem, but the I/O ports are accessed.
It is typically created by:
mknod -m 660 /dev/port c 1 4
chown root:kmem /dev/port
FILES¶
/dev/memSEE ALSO¶
chown(1), mknod(1), ioperm(2)COLOPHON¶
This page is part of release 4.10 of the Linux man-pages project. A description of the project, information about reporting bugs, and the latest version of this page, can be found at https://www.kernel.org/doc/man-pages/.2015-01-02 | Linux |