profile {
	output LVDS-1 disable
	output "Some Company ASDF 4242" mode 1600x900 position 0,0
}
profile nomad {
	output LVDS-1 enable scale 2
}

An output directive adds an output to the profile. The criteria can either be an output name, an output description or "*". The latter can be used to match any output.

On sway(1), output names and descriptions can be obtained via swaymsg -t get_outputs.

An exec directive executes a command when the profile was successfully applied. This can be used to update the compositor state to the profile when not done automatically.

Commands are executed asynchronously and their order may not be preserved. If you need to execute sequential commands, you should collect in one exec statement or in a separate script.

On sway(1) for example, exec can be used to move workspaces to the right output:

	multihead {
		output eDP-1 enable
		output DP-1 enable transform 270
		exec swaymsg workspace 1, move workspace to eDP-1
	}

Note that some extra care must be taken with outputs identified by an output description as the real name may change:

	complex {
		output "Some Other Company GTBZ 2525" mode 1920x1200
		exec swaymsg workspace 1, move workspace to output '"Some Other Company GTBZ 2525"'
	}

Enables or disables the specified output.

Configures the specified output to use the specified mode. Modes are a combination of width and height (in pixels) and a refresh rate (in Hz) that your display can be configured to use.

Examples:

Places the output at the specified position in the global coordinates space.

Example:

Scales the output by the specified scale factor.

Sets the output transform. Can be one of "90", "180", "270" for a rotation; or "flipped", "flipped-90", "flipped-180", "flipped-270" for a rotation and a flip; or "normal" for no transform.