|igmpproxy.conf(5)||File Formats Manual||igmpproxy.conf(5)|
igmpproxy.conf - Configuration file for igmpproxy(8) multicast daemon
igmpproxy.conf contains the configuration for the igmpproxy multicast daemon. It defines which network interfaces should be used by the routing daemon. Each interface must be give one of the following roles: upstream , downstream or disabled
The upstream network interface is the outgoing interface which is responsible for communicating to available multicast data sources. There can only be one upstream interface.
Downstream network interfaces are the distribution interfaces to the destination networks, where multicast clients can join groups and receive multicast data. One or more downstream interfaces must be configured.
On disabled network interfaces all IGMP or multicast traffic is ignored altogether. If multiple IP addresses is used on one single interface (ae. eth0:1 ...), all interface aliases not in use should be configured as disabled.
Any line in the configuration file starting with # is treated as a comment. Keywords and parameters can be distributed over many lines. The configuration file has two main keywords:
phyint interface role [ ratelimit limit ] [ threshold ttl ] [ altnet networkaddr ... ]
altnet networkaddr ...
This is especially useful for the upstream interface, since the source for multicast traffic is often from a remote location. Any number of altnet parameters can be specified.
By default all multicast groups are allowed on any downstream interface. If at least one whitelist entry is defined, all igmp membership reports for not explicitly whitelisted multicast groups will be ignored and therefore not be served by igmpproxy. This is especially useful, if your provider does only allow a predefined set of multicast groups. These whitelists are only obeyed by igmpproxy itself, they won't prevent any other igmp client running on the same machine as igmpproxy from requesting 'unallowed' multicast groups.
You may specify as many whitelist entries as needed. Although you should keep it as simple as possible, as this list is parsed for every membership report and therefore this increases igmp response times. Often used or large groups should be defined first, as parsing ends as soon as a group matches an entry.
You may also specify whitelist entries for the upstream interface. Only igmp membership reports for explicitly whitelisted multicast groups will be sent out on the upstream interface. This is useful if you want to use multicast groups only between your downstream interfaces, like SSDP from a UPnP server.
## Enable quickleave quickleave
## Define settings for eth0 (upstream)
phyint eth0 upstream
## Disable alternate IP on eth0 (eth0:0)
phyint eth0:0 disabled
## Define settings for eth1 (downstream)
phyint eth1 downstream ratelimit 0 threshold 1
## Define settings for eth2 (also downstream)
phyint eth2 downstream
Originally written by Johnny Egeland <firstname.lastname@example.org>