table of contents
ONEAC(8) | NUT Manual | ONEAC(8) |
NAME¶
oneac - Driver for Oneac UPS equipmentNOTE¶
This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).SUPPORTED HARDWARE¶
This driver supports various Oneac UPS families:•EG (late 80s, early 90s, plug-in serial interface
card)
•ON (early and mid-90s, plug-in serial interface
card)
•OZ (mid-90s on, DB-25 std., interface slot)
•OB (early 2000’s on, big cabinet, DB-25
std., interface slot)
If your UPS is equipped with the Basic Interface card, use the
genericups(8) driver.
EXTRA ARGUMENTS¶
This driver supports the following optional settings in the ups.conf(5) file: testtime=numChange battery test time from the 2 minute default.
offdelay=num
Change shutdown delay time from 0 second default.
INSTANT COMMANDS¶
This driver supports the following Instant Commands. (See upscmd(8))All UPS units¶
shutdown.returnTurn off the load possibly after a delay and return when
power is back.
shutdown.stop
Stop a shutdown in progress.
shutdown.reboot
Shut down the load briefly while rebooting the UPS.
test.failure.start
Starts a 15 second long simulation of an input power
failure.
test.battery.start.quick
Start a "quick" battery test. The default time
is 2 minutes. This time can be set in the ups.conf file. See
testime above.
test.battery.stop
Stops a battery test that is in progress.
All ON UPS units¶
reset.input.minmaxReset the minimum and maximum input line voltage values
seen since the last reset or power on.
Newer ON UPS units¶
test.panel.startStart testing the UPS panel.
test.battery.start.deep
Start a "deep" battery test. This test runs the
UPS until the low battery point and then returns to the AC line.
reset.input.minmax
Reset the minimum and maximum input line voltage values
seen since the last reset or power on.
beeper.enable
Enable UPS beeper/buzzer.
beeper.disable
Disable UPS beeper/buzzer.
beeper.mute
Mutes the UPS beeper/buzzer for the current alarm
condition(s).
WRITABLE VARIABLES¶
See upsrw(8) to see what variables are writable for the UPS.AUTHOR¶
Bill Elliot <bill@wreassoc.com>, Eric Lawson <elawson@inficad.com>SEE ALSO¶
The core driver:¶
nutupsdrv(8)Internet resources:¶
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/02/15/2014 | Network UPS Tools 2.7.1. |