table of contents
L2TEST(1) | General Commands Manual | L2TEST(1) |
NAME¶
l2test - L2CAP testingSYNOPSIS¶
l2testDESCRIPTION¶
l2test is L2CAP testing program.USAGE¶
l2test <mode> [options] [bdaddr] Modes:-r listen and receive
-w listen and send
-d listen and dump incoming data
-x listen, then send, then dump incoming data
-s connect and send
-u connect and receive
-n connect and be silent
-y connect, then send, then dump incoming data
-c connect, disconnect, connect, ...
-m multiple connects
-p trigger dedicated bonding
-z information request Options:
[ -b bytes] [-i device] [-P psm] [-J cid]
[ -I imtu] [-O omtu]
[ -L seconds] enable SO_LINGER
[ -W seconds] enable deferred setup
[ -B filename] use data packets from file
[ -N num] send num frames (default = infinite)
[ -C num] send num frames before delay (default = 1)
[ -D milliseconds] delay after sending num frames (default = 0)
[ -X mode] select retransmission/flow-control mode
[ -Q num] Max Transmit value (default = 3)
[ -Z size] Transmission Window size (default = 63)
[ -F fcs] use CRC16 check (default = 1)
[ -R] reliable mode
[ -G] use connectionless channel (datagram)
[ -U] use sock stream
[ -A] request authentication
[ -E] request encryption
[ -S] secure connection
[ -M] become master
[ -T] enable timestamps
AUTHOR¶
This manual page was written by Nobuhiro Iwamatsu <iwamatsu@debian.org>, for the Debian GNU/Linux system (but may be used by others).January 2012 |