|S390_RUNTIME_INSTR(2)||System Calls Manual||S390_RUNTIME_INSTR(2)|
s390_runtime_instr - enable/disable s390 CPU run-time instrumentation
int s390_runtime_instr(int command, int signum);
The s390_runtime_instr() system call starts or stops CPU run-time instrumentation for the calling thread.
The command argument controls whether run-time instrumentation is started (S390_RUNTIME_INSTR_START, 1) or stopped (S390_RUNTIME_INSTR_STOP, 2) for the calling thread.
The signum argument specifies the number of a real-time signal. This argument was used to specify a signal number that should be delivered to the thread if the run-time instrumentation buffer was full or if the run-time-instrumentation-halted interrupt had occurred. This feature was never used, and in Linux 4.4 support for this feature was removed; thus, in current kernels, this argument is ignored.
On success, s390_runtime_instr() returns 0 and enables the thread for run-time instrumentation by assigning the thread a default run-time instrumentation control block. The caller can then read and modify the control block and start the run-time instrumentation. On error, -1 is returned and errno is set to one of the error codes listed below.
- The value specified in command is not a valid command.
- The value specified in signum is not a real-time signal number. From Linux 4.4 onwards, the signum argument has no effect, so that an invalid signal number will not result in an error.
- Allocating memory for the run-time instrumentation control block failed.
- The run-time instrumentation facility is not available.
This system call is available since Linux 3.7.
This Linux-specific system call is available only on the s390 architecture. The run-time instrumentation facility is available beginning with System z EC12.
Glibc does not provide a wrapper for this system call, use syscall(2) to call it.
The asm/runtime_instr.h header file is available since Linux 4.16.
Starting with Linux 4.4, support for signalling was removed, as was the check whether signum is a valid real-time signal. For backwards compatibility with older kernels, it is recommended to pass a valid real-time signal number in signum and install a handler for that signal.
This page is part of release 5.10 of the Linux man-pages project. A description of the project, information about reporting bugs, and the latest version of this page, can be found at https://www.kernel.org/doc/man-pages/.
|2020-06-09||Linux Programmer's Manual|