Scroll to navigation

GCACHE(8) System Manager's Manual GCACHE(8)

NAME

gcachecontrol utility for CACHE GEOM class

SYNOPSIS

gcache create [-v] [-b blocksize] [-s size] name prov

gcache configure [-v] [-b blocksize] [-s size] name

gcache destroy [-fv] name

gcache label [-v] [-b blocksize] [-s size] name prov

gcache stop [-fv] name ...

gcache clear [-v] prov ...

gcache dump prov ...

gcache list

gcache status [-s name]

gcache load [-v]

gcache unload [-v]

DESCRIPTION

The gcache utility is used to control GEOM cache, which can speed up read performance by sending fixed size read requests to its consumer. It has been developed to address the problem of a horrible read performance of a 64k blocksize FS residing on a RAID3 array with 8 data components, where a single disk component would only get 8k read requests, thus effectively killing disk performance under high load.

Caching can be configured using two different methods: “manual” or “automatic”. When using the “manual” method, no metadata are stored on the devices, so the cached device has to be configured by hand every time it is needed. The “automatic” method uses on-disk metadata to detect devices. Once devices are labeled, they will be automatically detected and configured.

The first argument to gcache indicates an action to be performed:

Cache the given devices with specified name. This is the “manual” method. The kernel module geom_cache.ko will be loaded if it is not loaded already.
Cache the given devices with the specified name. This is the “automatic” method, where metadata are stored in every device's last sector. The kernel module geom_cache.ko will be loaded if it is not loaded already.
Turn off existing cache device by its name. This command does not touch on-disk metadata!
Same as stop.
Clear metadata on the given devices.
Dump metadata stored on the given devices.
See geom(8).
See geom(8).
See geom(8).
See geom(8).

Additional options:

Force the removal of the specified cache device.
Be more verbose.

SYSCTL VARIABLES

The following sysctl(8) variables can be used to control the behavior of the CACHE GEOM class. The default value is shown next to each variable.

kern.geom.cache.used_hi: 20
 
kern.geom.cache.used_lo: 5
 
kern.geom.cache.idletime: 5
 
kern.geom.cache.timeout: 10
 
kern.geom.cache.enable: 1
 
kern.geom.cache.debug: 0
Debug level of the CACHE GEOM class. This can be set to a number between 0 and 3 inclusive. If set to 0 minimal debug information is printed, and if set to 3 the maximum amount of debug information is printed.

EXIT STATUS

Exit status is 0 on success, and 1 if the command fails.

SEE ALSO

geom(4), geom(8)

HISTORY

The gcache utility appeared in FreeBSD 7.0.

AUTHORS

Ruslan Ermilov ⟨ru@FreeBSD.org⟩

January 3, 2010 Debian