|RSH(1)||General Commands Manual||RSH(1)|
rsh — remote
Rsh executes command
Rsh copies its standard input to the
remote command, the standard output of the remote command to its standard
output, and the standard error of the remote command to its standard error.
Interrupt, quit and terminate signals are propagated to the remote command;
rsh normally terminates when the remote command
does. The options are as follows:
-Koption turns off all Kerberos authentication.
-doption turns on socket debugging (using setsockopt(2)) on the TCP sockets used for communication with the remote host.
- By default, the remote username is the same as the local username. The
-loption allows the remote name to be specified. Kerberos authentication is used, and authorization is determined as in rlogin(1).
-noption redirects input from the special device /dev/null (see the BUGS section of this manual page).
If no command is specified, you will be logged in on the remote host using rlogin(1).
Shell metacharacters which are not quoted are interpreted on local machine, while quoted metacharacters are interpreted on the remote machine. For example, the command
rsh otherhost cat remotefile >> localfile
appends the remote file remotefile to the local file localfile, while
rsh otherhost cat remotefile ">>" other_remotefile
appends remotefile to other_remotefile.
rsh command appeared in
If you are using csh(1) and put a
rsh in the background without redirecting its input
away from the terminal, it will block even if no reads are posted by the
remote command. If no input is desired you should redirect the input of
rsh to /dev/null using the
Stop signals stop the local
only; this is arguably wrong, but currently hard to fix for reasons too
complicated to explain here.
|August 15, 1999||Linux NetKit (0.17)|