|solterm(1)||IPMI Serial over LAN program||solterm(1)|
solterm - An IPMI Serial over LAN program
<connection parms> [-e escape_char] [-notencrypted] [-notauthenticated] [-bitrate (9600|19200|38400|57600|115200)] [-alerts (succeed|defer|fail)] [-holdoff] [-ack-retries n] [-ack-timeout microseconds] [-v] [-q]
The solterm program allows a user to make a remote serial connection over IPMI. The requires that the remote system support IPMI 2.0 Serial Over LAN.
- <connection parms>
- The parameters for the connection depend on the connection type. These are all described in openipmi_conparms (7)
- -e escape_char
- The character to use to escape, or exit, the program. Entering this chatacter right after a newline is entered causes the program to go into command mode. A single character after this performs a command. The default escape character is "~" as shown below. Suppported commands are:
- Terminate the program
- Send a serial BREAK over the connection
- Flush all buffers
- Assert the Ring Indicator (RI) line
- Deassert the Ring Indicator (RI) line
- Assert DCD and DSR lines
- Deassert DCD and DSR lines
- Pause the output using CTS
- Put CTS under BMC control
- Help on escape commands
- Enter the escape character twice to send it.
- Do not encrypt the SOL data going over the connection.
- Do not do integrity checks on the SOL data going over the connection.
- Set the bitrate to the given value. The default is whatever the BMC has set it to.
- This specifies what to do if a alert that requires a callout occurs on the line.
- Specifies that CTS, DTR, and DSR are to be deasserted at the start of the SoL session so that the configuration may be modifeid before the handshake is released.
- Be more verbose. Maybe specified multiple time for more output.
- Be less verbose. Maybe specified multiple time for less output.
Darius Davis <email@example.com>