Scroll to navigation

NG_PPTPGRE(4) Device Drivers Manual NG_PPTPGRE(4)

NAME

ng_pptpgrePPTP GRE protocol netgraph node type

SYNOPSIS

#include <sys/types.h>
#include <netgraph/ng_pptpgre.h>

DESCRIPTION

The pptpgre node type performs Generic Routing Encapsulation (GRE) over IP for the PPTP protocol as specified by RFC 2637. This involves packet encapsulation, sequencing, acknowledgement, and an adaptive timeout sliding window mechanism. This node type does not handle any of the TCP control protocol or call negotiation defined by PPTP.

This node type expects to receive complete IP packets, including the IP header, on the “lower” hook, but it transmits outgoing frames without any IP header. The typical use for this node type would be to connect the “upper” hook to one of the link hooks of a ng_ppp(4) node, and the “lower” hook to the “inet/raw/gre” hook of a ng_ksocket(4) node.

HOOKS

This node type supports the following hooks:

session_hhhh
Session 0xhhhh data packets to the upper protocol layers
upper
Same as session_hhhh, but for single session with configurable cid (legacy)
lower
Connection to the lower protocol layers

CONTROL MESSAGES

This node type supports the generic control messages, plus the following:

(setconfig)
This command resets and configures hook for a session. If corresponding session_hhhh hook is not connected, upper hook will be configured. This command takes a struct ng_pptpgre_conf as an argument:
/* Configuration for a session */
struct ng_pptpgre_conf {
    u_char      enabled;          /* enables traffic flow */
    u_char      enableDelayedAck; /* enables delayed acks */
    u_char      enableAlwaysAck;  /* always include ack with data */
    u_char      enableWindowing;  /* enable windowing algorithm */
    uint16_t    cid;              /* my call id */
    uint16_t    peerCid;          /* peer call id */
    uint16_t    recvWin;          /* peer recv window size */
    uint16_t    peerPpd;          /* peer packet processing delay
                                     (in 1/10 of a second) */
};

The enabled field enables traffic flow through the node. The enableDelayedAck field enables delayed acknowledgement (maximum 250 milliseconds), which is a useful optimization and should generally be turned on. enableAlwaysAck field enables sending acknowledgements with every data packet, which is probably helpful as well.

enableWindowing enables the PPTP packet windowing mechanism specified by the protocol. Disabling this will cause the node to violate the protocol, possibly confusing other PPTP peers, but often results in better performance. The windowing mechanism is a design error in the PPTP protocol; L2TP, the successor to PPTP, removes it.

The remaining fields are as supplied by the PPTP virtual call setup process.

(getconfig)
Takes two byte argument as cid and returns the current configuration as a struct ng_pptpgre_conf.
(getstats)
This command returns a struct ng_pptpgre_stats containing various node statistics.
(clrstats)
This command resets the node statistics.
(getclrstats)
This command atomically gets and resets the node statistics, returning a struct ng_pptpgre_stats.

SHUTDOWN

This node shuts down upon receipt of a NGM_SHUTDOWN control message, or when both hooks have been disconnected.

SYSCTL VARIABLES

A set of sysctl(8) variables controls ability of this node to deal with some amount of packet reorder that sometimes happens in transit. Packet reorder results in packet drops (unless the order is restored) as PPP protocol can not deliver reordered data. These variables are shown below together with their default value and meaning:

net.graph.pptpgre.reorder_max: 1
Defines maximum length of node's private reorder queue used to keep data waiting for late packets. Zero value disables reordering. Default value allows the node to restore the order for two packets swapped in transit. Greater values allow the node to deliver packets being late after more packets in sequence at cost of increased kernel memory usage.
net.graph.pptpgre.reorder_timeout: 1
Defines time value in miliseconds used to wait for late packets.

SEE ALSO

netgraph(4), ng_ksocket(4), ng_ppp(4), ngctl(8), sysctl(8)

K. Hamzeh, G. Pall, W. Verthein, J. Taarud, W. Little, and G. Zorn, Point-to-Point Tunneling Protocol (PPTP), RFC 2637.

S. Hanks, T. Li, D. Farinacci, and P. Traina, Generic Routing Encapsulation over IPv4 networks, RFC 1702.

HISTORY

The ng_pptpgre node type was implemented in FreeBSD 4.0.

AUTHORS

Archie Cobbs <archie@FreeBSD.org>

BUGS

The node should not expect incoming GRE packets to have an IP header. This behavior is inherited from the (converse) behavior of raw IP sockets. An intermediate node that strips IP headers in one direction should be used instead.

November 4, 2018 Debian