- bullseye 0.18.0+ds-2
- bullseye-backports 0.22.0+ds-2~bpo11+1
- testing 0.25.0+ds-2
- unstable 0.26.0+ds-1
- experimental 0.26.0+ds-2~experimental1
|tcpretrans(8)||System Manager's Manual||tcpretrans(8)|
tcpretrans - Trace or count TCP retransmits and TLPs. Uses Linux eBPF/bcc.
tcpretrans [-h] [-s] [-l] [-c] [-4 | -6]
This traces TCP retransmits, showing address, port, and TCP state information, and sometimes the PID (although usually not, since retransmits are usually sent by the kernel on timeouts). To keep overhead very low, only the TCP retransmit functions are traced. This does not trace every packet (like tcpdump(8) or a packet sniffer). Optionally, it can count retransmits over a user signalled interval to spot potentially dropping network paths the flows are traversing.
This uses dynamic tracing of the kernel tcp_retransmit_skb() and tcp_send_loss_probe() functions, and will need to be updated to match kernel changes to these functions.
Since this uses BPF, only the root user can use this tool.
CONFIG_BPF and bcc.
- Trace TCP retransmits:
- # tcpretrans
- Trace TCP retransmits and TLP attempts:
- # tcpretrans -l
- Trace IPv4 family only:
- # tcpretrans -4
- Trace IPv6 family only:
- # tcpretrans -6
- Time of the retransmit.
- Process ID that was on-CPU. This is less useful than it might sound, as it may usually be 0, for the kernel, for timer-based retransmits.
- IP address family (4 or 6).
- Local IP address.
- Local port.
- Type of event: R> == retransmit, L> == tail loss probe.
- Remote IP address.
- Remote port.
- TCP session state.
- TCP sequence.
- Accumulated occurred retransmits since start.
Should be negligible: TCP retransmit events should be low (<1000/s), and the low overhead this tool adds to each event should make the cost negligible.
This is from bcc.
Also look in the bcc distribution for a companion _examples.txt file containing example usage, output, and commentary for this tool.
Unstable - in development.