|AE(4)||Device Drivers Manual||AE(4)|
SYNOPSIS¶To compile this driver into the kernel, place the following lines in your kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
aedevice driver provides support for Attansic/Atheros L2 PCIe FastEthernet controllers.
The controller supports hardware Ethernet checksum processing, hardware VLAN tag stripping/insertion and an interrupt moderation mechanism. Attansic L2 also features a 64-bit multicast hash filter.
ae driver supports the following media
- Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf(5).
- Select 10Mbps operation.
- Set 100Mbps (FastEthernet) operation.
ae driver provides support for the
following media options:
For more information on configuring this device, see ifconfig(8).
aedriver supports Attansic/Atheros L2 PCIe FastEthernet controllers, and is known to support the following hardware:
- ASUS EeePC 701
- ASUS EeePC 900
Other hardware may or may not work with this driver.
LOADER TUNABLES¶Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5).
- This tunable disables MSI support on the Ethernet hardware. The default value is 0.
aedriver collects a number of useful MAC counter during the work. The statistics is available via the dev.ae.%d.stats sysctl(8) tree, where %d corresponds to the controller number.
- ae%d: watchdog timeout.
- The device has stopped responding to the network, or there is a problem with the network connection (cable).
- ae%d: reset timeout.
- The card reset operation has been timed out.
- ae%d: Generating random ethernet address.
- No valid Ethernet address was found in the controller NVRAM and registers. Random locally administered address with ASUS OUI identifier will be used instead.
SEE ALSO¶altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), vlan(4), ifconfig(8)
aedriver and this manual page was written by Stanislav Sedov <stas@FreeBSD.org>. It first appeared in FreeBSD 7.1.
BUGS¶The Attansic L2 FastEthernet controller supports DMA but does not use a descriptor based transfer mechanism via scatter-gather DMA. Thus the data should be copied to/from the controller memory on each transmit/receive. Furthermore, a lot of data alignment restrictions apply. This may introduce a high CPU load on systems with heavy network activity. Luckily enough this should not be a problem on modern hardware as L2 does not support speeds faster than 100Mbps.
|October 4, 2008||Linux 4.9.0-9-amd64|