|tabs(1)||General Commands Manual||tabs(1)|
NAME¶tabs - set tabs on a terminal
SYNOPSIS¶tabs [options]] [tabstop-list]
DESCRIPTION¶The tabs program clears and sets tab-stops on the terminal. This uses the terminfo clear_all_tabs and set_tab capabilities. If either is absent, tabs is unable to clear/set tab-stops. The terminal should be configured to use hard tabs, e.g.,
- Tell tabs which terminal type to use. If this option is not given, tabs will use the $TERM environment variable. If that is not set, it will use the ansi+tabs entry.
- The debugging option shows a ruler line, followed by two data lines. The first data line shows the expected tab-stops marked with asterisks. The second data line shows the actual tab-stops, marked with asterisks.
- This option tells tabs to check the options and run any debugging option, but not to modify the terminal settings.
- reports the version of ncurses which was used in this program, and exits.
Implicit Lists¶Use a single number as an option, e.g., " -5" to set tabs at the given interval (in this case 1, 6, 11, 16, 21, etc.). Tabs are repeated up to the right margin of the screen. Use " -0" to clear all tabs. Use " -8" to set tabs to the standard interval.
Explicit Lists¶An explicit list can be defined after the options (this does not use a "-"). The values in the list must be in increasing numeric order, and greater than zero. They are separated by a comma or a blank, for example,
tabs 1,6,11,16,21tabs 1 6 11 16 21Use a '+' to treat a number as an increment relative to the previous value, e.g.,
tabs 1,+5,+5,+5,+5which is equivalent to the 1,6,11,16,21 example.
Predefined Tab-Stops¶X/Open defines several predefined lists of tab stops.
- Assembler, IBM S/370, first format
- Assembler, IBM S/370, second format
- COBOL, normal format
- COBOL compact format
- COBOL compact format extended
- UNIVAC 1100 Assembler