Scroll to navigation

ENUM MAC80211_RX_FLA(9) The basic mac80211 driver inte ENUM MAC80211_RX_FLA(9)

NAME

enum_mac80211_rx_flags - receive flags

SYNOPSIS

enum mac80211_rx_flags {
  RX_FLAG_MMIC_ERROR,
  RX_FLAG_DECRYPTED,
  RX_FLAG_MMIC_STRIPPED,
  RX_FLAG_IV_STRIPPED,
  RX_FLAG_FAILED_FCS_CRC,
  RX_FLAG_FAILED_PLCP_CRC,
  RX_FLAG_MACTIME_START,
  RX_FLAG_SHORTPRE,
  RX_FLAG_HT,
  RX_FLAG_40MHZ,
  RX_FLAG_SHORT_GI,
  RX_FLAG_NO_SIGNAL_VAL,
  RX_FLAG_HT_GF,
  RX_FLAG_AMPDU_DETAILS,
  RX_FLAG_AMPDU_REPORT_ZEROLEN,
  RX_FLAG_AMPDU_IS_ZEROLEN,
  RX_FLAG_AMPDU_LAST_KNOWN,
  RX_FLAG_AMPDU_IS_LAST,
  RX_FLAG_AMPDU_DELIM_CRC_ERROR,
  RX_FLAG_AMPDU_DELIM_CRC_KNOWN,
  RX_FLAG_MACTIME_END,
  RX_FLAG_VHT,
  RX_FLAG_LDPC,
  RX_FLAG_STBC_MASK,
  RX_FLAG_10MHZ,
  RX_FLAG_5MHZ,
  RX_FLAG_AMSDU_MORE
};  

CONSTANTS

RX_FLAG_MMIC_ERROR
Michael MIC error was reported on this frame. Use together with RX_FLAG_MMIC_STRIPPED.
RX_FLAG_DECRYPTED
This frame was decrypted in hardware.
RX_FLAG_MMIC_STRIPPED
the Michael MIC is stripped off this frame, verification has been done by the hardware.
RX_FLAG_IV_STRIPPED
The IV/ICV are stripped from this frame. If this flag is set, the stack cannot do any replay detection hence the driver or hardware will have to do that.
RX_FLAG_FAILED_FCS_CRC
Set this flag if the FCS check failed on the frame.
RX_FLAG_FAILED_PLCP_CRC
Set this flag if the PCLP check failed on the frame.
RX_FLAG_MACTIME_START
The timestamp passed in the RX status (mactime field) is valid and contains the time the first symbol of the MPDU was received. This is useful in monitor mode and for proper IBSS merging.
RX_FLAG_SHORTPRE
Short preamble was used for this frame
RX_FLAG_HT
HT MCS was used and rate_idx is MCS index
RX_FLAG_40MHZ
HT40 (40 MHz) was used
RX_FLAG_SHORT_GI
Short guard interval was used
RX_FLAG_NO_SIGNAL_VAL
The signal strength value is not present. Valid only for data frames (mainly A-MPDU)
RX_FLAG_HT_GF
This frame was received in a HT-greenfield transmission, if the driver fills this value it should add IEEE80211_RADIOTAP_MCS_HAVE_FMT to hw.radiotap_mcs_details to advertise that fact
RX_FLAG_AMPDU_DETAILS
A-MPDU details are known, in particular the reference number ( ampdu_reference) must be populated and be a distinct number for each A-MPDU
RX_FLAG_AMPDU_REPORT_ZEROLEN
driver reports 0-length subframes
RX_FLAG_AMPDU_IS_ZEROLEN
This is a zero-length subframe, for monitoring purposes only
RX_FLAG_AMPDU_LAST_KNOWN
last subframe is known, should be set on all subframes of a single A-MPDU
RX_FLAG_AMPDU_IS_LAST
this subframe is the last subframe of the A-MPDU
RX_FLAG_AMPDU_DELIM_CRC_ERROR
A delimiter CRC error has been detected on this subframe
RX_FLAG_AMPDU_DELIM_CRC_KNOWN
The delimiter CRC field is known (the CRC is stored in the ampdu_delimiter_crc field)
RX_FLAG_MACTIME_END
The timestamp passed in the RX status (mactime field) is valid and contains the time the last symbol of the MPDU (including FCS) was received.
RX_FLAG_VHT
VHT MCS was used and rate_index is MCS index
RX_FLAG_LDPC
LDPC was used
RX_FLAG_STBC_MASK
STBC 2 bit bitmask. 1 - Nss=1, 2 - Nss=2, 3 - Nss=3
RX_FLAG_10MHZ
10 MHz (half channel) was used
RX_FLAG_5MHZ
5 MHz (quarter channel) was used
RX_FLAG_AMSDU_MORE
Some drivers may prefer to report separate A-MSDU subframes instead of a one huge frame for performance reasons. All, but the last MSDU from an A-MSDU should have this flag set. E.g. if an A-MSDU has 3 frames, the first 2 must have the flag set, while the 3rd (last) one must not have this flag set. The flag is used to deal with retransmission/duplication recovery properly since A-MSDU subframes share the same sequence number. Reported subframes can be either regular MSDU or singly A-MSDUs. Subframes must not be interleaved with other frames.

DESCRIPTION

These flags are used with the flag member of struct ieee80211_rx_status.

AUTHOR

Johannes Berg <johannes@sipsolutions.net>
Author.

COPYRIGHT

May 2018 Kernel Hackers Manual 3.16