NAME¶
vboxgetty.conf - config file for vboxgetty
Description¶
The file
/etc/isdn/vboxgetty.conf is used to configure vboxgetty. Please
read the man page
vboxgetty(8) for a description of how vboxgetty works.
Everything after "#" is ignored, as are empty lines. All arguments
must be separated by whitespace (spaces, tabs). Arguments may not contain
whitespace.
All settings before the first
port command are global settings, after a
port command they only affect the current port.
- port <string>
- ISDN device to configure.
- modeminit <string>
- Command to initialize the modem. You should set the MSN/EAZ on which
vboxgetty should listen for incoming calls. Default is "ATZ".
- user <string>
- Name of the user that vboxgetty will use. This user must exist in
/etc/passwd and you must use this parameter.
- group <string>
- Name of the group that vboxgetty will use. This group must exist in
/etc/group and you must use this parameter.
- umask <number>
- Vboxgetty will use this umask when creating new files. You must give the
umask as an octal number. Default is 077.
- dropdtrtime <seconds>
- Number of milliseconds to hold the DTR-Line low to reset the modem.
Default value is 800.
- initpause <number>
- Number of milliseconds to wait after initializing the modem. This is used
to compensate the delay of the "NO CARRIER" response. Default
value is 1500.
- badinitsexit <number>
- Maximum failures with modeminit. If this number is reached, vboxgetty
exits. Default is 0.
- ringtimeout <number>
- Time in seconds to wait for a RING. If no RING is received within this
time, no call is taken. Default is 5.
- echotimeout <number>
- Time in seconds to wait for the echo from the modem. Default is 4.
- commandtimeout <number>
- Time in seconds to wait for a response to a modem command. Default is 4.
- alivetimeout <number>
- After this time in seconds vboxgetty will check if the modem is still
responding to modem commands. Default is 1800.
- compression <string>
- Audio compression to use to record new messages. Possible values are
ADPCM-2, ADPCM-3, ADPCM-4 and ULAW. The ALAW compression mode is no longer
supported. Default is ULAW.
- spooldir <string>
- Spool directory to use. This directory must exist. It's used for control
files of several programs. Default is /var/spool/vbox/<user>.
- vboxconfig <string>
- Full path of the vbox config file. Default value is
<spooldir>/vbox.conf.
- freespace <number>
- Number of bytes that must be available on the partition with the spool
directory, so that a call may be taken. Default is 0.
- debuglevel <string>
- What messages are be written to
/var/log/vbox/vboxgetty-<device>.log. The string consists of letters
representing the severities of the messages to log (F=FATAL, E=ERROR,
W=WARNING, I=INFO, D=DEBUG, J=JUNK). Default is FEWI.
FILES¶
- /etc/isdn/vboxgetty.conf
- this configuration file
SEE ALSO¶
vboxgetty(8), vbox(5), vboxtcl(5)
AUTHOR¶
This manual page was written by Andreas Jellinghaus <aj@dungeon.inka.de>,
for Debian GNU/Linux and isdn4linux.