NAME¶
de
—
DEC DC21x4x Ethernet device driver
SYNOPSIS¶
To compile this driver into the kernel, place the following line in your kernel
configuration file:
device de
Alternatively, to load the driver as a module at boot time, place the following
line in
loader.conf(5):
DESCRIPTION¶
The
de
driver provides support for the
Ethernet adapters based on the Digital Equipment DC21x4x based self-contained
Ethernet and Fast Ethernet chips.
The
de
driver supports the following media
types:
- autoselect
- Enable autoselection of the media type and options
- 10baseT/UTP
- Set 10Mbps operation on the 10baseT port
- 10base2/BNC
- Set 10Mbps operation on the BNC port
- 10base5/AUI
- Set 10Mbps operation on the AUI port
- 100baseTX
- Set 100Mbps (Fast Ethernet) operation
- 100baseFX
- Set 100Mbps operation
- 100baseT4
- Set 100Mbps operation (4-pair cat-3 cable)
The
de
driver supports the following media
options:
- full-duplex
- Set full duplex operation
Note that the media types available depend on the particular card in use. Some
cards are explicitly programmed to a particular media type by a setup utility
and are not changeable.
Use the
ifconfig(8) command and in particular the
-m
flag to list the supported media types
for your particular card.
The old “ifconfig linkN” method of configuration is not supported.
HARDWARE¶
Adapters supported by the
de
driver include:
- Adaptec ANA-6944/TX
- Cogent EM100FX and EM440TX
- Corega FastEther PCI-TX
- D-Link DFE-500TX
- DEC DE435, DEC DE450, and DEC DE500
- ELECOM LD-PCI2T, LD-PCITS
- I-O DATA LA2/T-PCI
- SMC Etherpower 8432, 9332 and 9334
- ZNYX ZX3xx
DIAGNOSTICS¶
- de%d: waking device from sleep/snooze mode
- The 21041 and 21140A chips support suspending the operation of the
card.
- de%d: error: desired IRQ of %d does not match device's actual IRQ of
%d
- The device probe detected that the board is configured for a different
interrupt than the one specified in the kernel configuration file.
- de%d: not configured; limit of %d reached or exceeded
- There is a limit of 32
de
devices
allowed in a single machine.
- de%d: not configured; 21040 pass 2.0 required (%d.%d found)
- de%d: not configured; 21140 pass 1.1 required (%d.%d found)
- Certain revisions of the chipset are not supported by this driver.
SEE ALSO¶
altq(4),
arp(4),
netintro(4),
ng_ether(4),
ifconfig(8)
AUTHORS¶
The
de
device driver was written by
Matt Thomas. This manual page was written
by
David E. O'Brien.