table of contents
other versions
- jessie 3.1.5-2
fence_xcat(8) | System Manager's Manual | fence_xcat(8) |
NAME¶
fence_xcat - I/O Fencing agent for xcat environmentsSYNOPSIS¶
fence_xcat [ OPTION]...DESCRIPTION¶
fence_xcat is a wrapper to the rpower(1) command that is distributed with the xCAT project available at http://www.xcat.org. Use of fence_xcat requires that xcat has already been properly configured for your environment. Refer to xCAT(1) for more information on configuring xCAT. fence_xcat accepts options on the command line as well as from stdin. fenced sends parameters through stdin when it execs the agent. fence_xcat can be run by itself with command line options which is useful for testing. NOTE: It is recommended that fence_bladecenter(8) is used instead of fence_xcat if the bladecenter firmware supports telnet. This interface is much cleaner and easier to setup. Vendor URL: http://www.xcat.orgOPTIONS¶
- -h
- Print out a help message describing available options, then exit.
- -n nodename
- The nodename as defined in nodelist.tab of the xCAT setup.
- -o action
- The action required. on, off, reset (default) or stat.
- -r rpower
- The path to the rpower binary.
- -q
- Quiet mode: print only error messages.
- -V
- Print out a version message, then exit.
STDIN PARAMETERS¶
- agent = < param >
- This option is used by fence_node(8) and is ignored by fence_xcat.
- nodename = < param >
- The nodename as defined in nodelist.tab of the xCAT setup.
- action = < param >
- The action required. on, off, reset (default) or stat.
- rpower = < param >
- The path to the rpower binary.