|ARPSPOOF(8)||System Manager's Manual||ARPSPOOF(8)|
NAME¶arpspoof - intercept packets on a switched LAN
arpspoof [-i interface] [-c own|host|both] [-t target] [-r] host
arpspoof redirects packets from a target host (or all hosts) on the LAN intended for another host on the LAN by forging ARP replies. This is an extremely effective way of sniffing traffic on a switch. Kernel IP forwarding (or a userland program which accomplishes the same, e.g. fragrouter(8)) must be turned on ahead of time.
- -i interface
- Specify the interface to use.
- -c own|host|both
- Specify which hardware address t use when restoring the arp configuration; while cleaning up, packets can be send with the own address as well as with the address of the host. Sending packets with a fake hw address can disrupt connectivity with certain switch/ap/bridge configurations, however it works more reliably than using the own address, which is the default way arpspoof cleans up afterwards.
- -t target
- Specify a particular host to ARP poison (if not specified, all hosts on the LAN). Repeat to specify multiple hosts.
- Poison both hosts (host and target) to capture traffic in both directions. (only valid in conjuntion with -t)
- Specify the host you wish to intercept packets for (usually the local gateway).
SEE ALSO¶dsniff(8), fragrouter(8)
Dug Song <email@example.com>