NAME¶
xpp_sync - Handle sync selection of Xorcom Astribanks.
SYNOPSIS¶
xpp_sync <auto|dahdi|nn>
xpp_sync [-v]
DESCRIPTION¶
On a normal operation one Astribank device provides timing for all the other
Astribank devices.
When run without parameters, xpp_sync will display a list of Astribanks (xbuses)
that are connected and registered as Dahdi spans. The current xpp sync master
will be marked.
If you this an Astribank is connected and yet it does not appear on the output
of xpp_sync, it may be unregistered. Try running dahdi_registration .
Parameters¶
- auto
- Automatically selects the best Astribank for syncing.
- dahdi
- Gets synchronization from the Dahdi sync master.
- nn
- Sets XBUS-nn as sync source.
- -v
- Also print the numeric xpp sync rank.
(Parameter name is case-insensitive)
Example output:¶
Setting SYNC
Current sync: 01
Best Available Syncers:
+ XBUS-01 (usb-0000:00:10.4-3) [usb:12345678] [ PRI_TE PRI_NT PRI_TE PRI_NT ]
XBUS-00 (usb-0000:00:10.4-2) [usb:QA-01] [ FXS FXO ]
==================================================
WARNING: FXO which is not the syncer cause bad PCM
Affected Astribanks are:
--------------------------------------------------
XBUS-00
==================================================
In this example we see that the recommended xpp sync master is XBUS-02 - it is
the first on the list. It is also the actual syncer, as we can see from the
'+' beside it.
xpp_sync is normally called from the dahdi init.d script. The parameter it is
called with defaults to
auto, but it is possible to override that
parameter (e.g: set it to
dahdi) through the value of XPP_SYNC in
/etc/dahdi/init.conf .
FILES¶
- /sys/bus/astribanks/drivers/xppdrv/sync
- xpp_sync is essentially a nicer interface to
"/sys/bus/astribanks/drivers/xppdrv/sync". That file shows the
current xpp sync master.
Writing to it, force XPP drivers to use a different sync master
SEE ALSO¶
dahdi_registration(1),
dahdi_cfg(1), README.Astribank