NAME¶

dmascc_cfg - Configure dmascc devices

SYNOPSIS¶

dmascc <interface> [<options>]

DESCRIPTION¶

dmascc_cfg is used to configure dmascc devices such as PI2 and PackeTwin cards. The --show option can be used by any user, all other options must be used by root.

OPTIONS¶

--speed frequency

Set frequency of baud rate generator to frequency. A value of 0 disables the baud rate generator and the digital PLL. Use the --show option to check whether the frequency you selected could be approximated with sufficient accuracy.

--nrzi [0|1]

0 selects NRZ mode, 1 selects NRZI mode.

--clocks integer

Set the clock mode. You may OR together three choices (other values are not supported and may cause strange results).

TX clock pin:

0x00 input

 

0x05 output TX clock *

 

0x06 output baud rate generator *

 

0x07 output digital PLL *

TX clock source:

0x00 RX clock pin

 

0x08 TX clock pin #

 

0x10 baud rate generator

 

0x18 digital PLL +

 

RX clock source:

0x00 RX clock pin

 

0x20 TX clock pin

 

0x40 baud rate generator

 

0x60 digital PLL +

 

* Not allowed on PI2 Port A if J3 is installed. # TX clock pin must be configured as input. + Speed must be equal to 32 times the baud rate.

--txdelay milliseconds

Set transmit delay to milliseconds. Maximum is 2500 ms.

--txtime seconds

Set maximum time the transmitter may be active to seconds.

--sqdelay milliseconds

Set the squelch delay to milliseconds. Maximum delay is 2500 ms.

--slottime milliseconds

Set the slot time to milliseconds. Maximum slottime is 2500 ms.

--waittime milliseconds

Set the minimum time between the transmitter turning off to when it turns on to milliseconds. Maximum wait time is 2500 ms.

--persist f

Set the persistance parameter to f. Must be between 0 and 255 (inclusive).

--dma channel

Set the DMA channel to channel. Can be 1 or 3. Setting to 0 disables DMA.

BUGS¶

dmascc_cfg does not check the parameters for validity. The driver or kernel may crash if you specify invalid values.

AUTHORS¶

Klaus Kudielka
 
This manual page written by Craig Small <csmall@small.dropbear.id.au>