table of contents
rtcSetGeometryMaxRadiusScale(3)  Embree Ray Tracing Kernels 3  rtcSetGeometryMaxRadiusScale(3) 
NAME¶

rtcSetGeometryMaxRadiusScale  assigns a maximal curve radius scale factor for minwidth feature
SYNOPSIS¶

#include <embree3/rtcore.h> void rtcSetGeometryMaxRadiusScale(RTCGeometry geometry, float maxRadiusScale);
DESCRIPTION¶
The rtcSetMaxGeometryScale function specifies a maximal scaling factor for curve radii used by the minwidth feature.
The minwidth feature can increase the radius of curves and points, in order to reduce aliasing and improve render times. The feature is disabled by default and has to get enabled using the EMBREE_MIN_WIDTH cmake option.
To use the feature, one has to specify a maximal curve radius scaling factor using the [rtcSetGeometryMaxRadiusScale] function. This factor should be a small number (e.g. 4) as the constructed BVH bounds get increased in order to bound the curve in the worst case of maximal radii.
One also has to set the minWidthDistanceFactor in the RTCIntersectContext when tracing a ray. This factor controls the target radius size of a curve or point at some distance away of the ray origin.
For each control point p with radius r of a curve or point primitive, the primitive intersectors first calculate a target radius r’ as:

r' = length(pray_org) * minWidthDistanceFactor
Typically the minWidthDistanceFactor is set by the application such that the target radius projects to the width of half a pixel (thus primitive diameter is pixel sized).
The target radius r’ is then clamped against the minimal bound r and maximal bound maxRadiusScale*r to obtain the final radius r’’:

r'' = max(r, min(r', maxRadiusScale*r))
Thus curves or points close to the camera are rendered with a normal radii r, and curves or points far from the camera are not enlarged too much, as this would be very expensive to render.
When rtcSetGeometryMaxRadiusScale function is not invoked for a curve or point geometry (or if the maximal scaling factor is set to 1.0), then the curve or point geometry renders normally, with radii not modified by the minwidth feature.
EXIT STATUS¶
On failure an error code is set that can be queried using rtcGetDeviceError.
SEE ALSO¶
[rtcInitIntersectContext]