|GNUNET-GNS(1)||General Commands Manual||GNUNET-GNS(1)|
gnunet-gnscan be used to lookup and process GNU Name Service names.
- Use the configuration file FILENAME.
- Print short help on options.
- Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- Write logs to FILENAME.
- No unneeded output. This is a quiet mode where only important information is displayed. For example a lookup for an IP address will only yield the IP address, no descriptive text.
- Resource Record Type (TYPE) to look for. Supported TYPE's are: A, AAAA, CNAME, NS, PKEY, PSEU, TLSA, SRV, SOA, MX, LEHO, VPN, REV, PTR, TXT. Defaults to "A".
- Name to lookup. Resolve the specified name using the GNU Name System.
- How much time to wait for a resolution to finish. Example: "5s" for 5 seconds or "3m" for 3 minutes. Defaults to "forver" (No timeout).
- Print GNUnet version number.
gnunet-gnswill return 0 on success, 1 on internal failures, 2 on launch failures, 4 if the given name is not configured to use GNS.
SEE ALSO¶gnunet-namestore(1), gnunet-identity(1)
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
should give you access to the complete handbook,
will give you access to a tutorial for developers.
BUGS¶Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <email@example.com>.
|March 23, 2018||Linux 4.19.0-14-amd64|