table of contents
- bullseye 0.13.1-2
- testing 0.19.3-1
- unstable 0.19.3-2
- experimental 0.19.4-2
|GNUNET-CADET(1)||General Commands Manual||GNUNET-CADET(1)|
create or obtain information about CADET tunnels and
gnunet-cadet prints information about
CADET tunnels and peers. It can also be used for command-line based CADET
tunnels using the
SHARED_SECRET option to open a port on a receiving
PEER_ID and using
⟨SHARED_SECRET⟩ to establish one circuit
to that peer from any other peer. The receiving process will only accept one
incoming circuit, but several commands using the same
-o can be issued to satisfy multiple requests. For
one-to-many communication gnunet-social(1) may be better
- Provide information about the connection CONNECTION_ID.
- Dump debug information to stderr.
- Activate echo mode.
- Listen for connections using a shared secret, provided as SHARED_SECRET, among sender and recipient.
- Provide information about the peer PEER_ID.
- Provide information about all (known) peers.
- Provide information about all tunnels.
- Use the configuration file FILENAME.
- Print the help page.
- Configure logging to write logs to FILENAME.
- Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- Print the GNUnet version number.
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
should give you access to the complete handbook,
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <firstname.lastname@example.org>.
|May 3, 2016||Debian|