|GNUNET-ATS(1)||General Commands Manual||GNUNET-ATS(1)|
gnunet-atscan be used to display information about the GNUnet's transport selection mechanism. It shows information about the addresses and the assigned input and output bandwidth.
- List all addresses currently known to ats.
- Ask ATS to suggest an address for PEERID to transport to establish a connection. Note that you can use the gnunet-transport(1) commandline tool to force disconnects.
- Use the configuration file FILENAME.
- Print short help on options.
- Print information for a specific peer identity only.
- Value to set for when changing preference values.
- Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
- Monitor changes to the bandwidth assignments continuously.
- Do not resolve IP addresses to hostnames.
- Set preference values, -i, -k and -t required.
- Print quotas for all network types
- Preference type to change: latency | bandwidth
- Print addresses actively used only
- Print verbose output (include ATS address properties)
- v | -version
- Print GNUnet version number.
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
should give you access to the complete handbook,
will give you access to a tutorial for developers.
BUGS¶Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <email@example.com>.
|October 16, 2015||Linux 4.19.0-14-amd64|