Scroll to navigation

opapacketcapture(1) Master map: IFSFFCLIRG (Man Page) opapacketcapture(1)

NAME

opapacketcapture

Starts capturing packet data.

To stop capture and trigger dump, use SIGINT or SIGUSR1. Program dumps packets to file and exits.

NOTE: Using opapacketcapture with large amounts of traffic can cause performance issues on the given host. Intel recommends you use opapacketcapture on hosts with lower packet rates and bandwidth.

Syntax

opapacketcapture [-o outfile] [-d devfile] [-f filterfile]
[-t triggerfile] [-l triggerlag][-a alarm] [-p packets] [-s maxblocks]
[-v [-v]]

Options

--help
Produces full help text.

-o outfile
Specifies the output file for captured packets.
Default is packetDump.pcap

-d devfile
Specifies the device file for capturing packets.

-f filterfile
Specifies the file used for filtering. If absent, no filtering is done.

-t triggerfile
Specifies the file used for triggering a stop capture. If absent, normal triggering is performed.

-l triggerlag
Specifies the number of packets to collect after trigger condition is met, before dumping data and exiting. Default is 10.

-a alarm
Specifies the number of seconds for alarm trigger to dump capture and exit.

-p packets
Specifies the number of packets for alarm trigger to dump capture and exit.

-s maxblocks
Specifies the number of blocks to allocate for ring buffer. Value is in Millions. Default is 2 which corresponds to 128 MiB because 1 block = 64 Bytes.

-v
Produces verbose output. (Use verbose Level 1+ to show levels.)

Example

# opapacketcapture
opapacketcapture: Capturing packets using 128 MiB buffer
^C
opapacketcapture: Triggered
Number of packets stored is 100

In the example above, opapacketcapture operates until CTRL+C is entered.

Intel Corporation Copyright(C) 2015-2018