Scroll to navigation
||General Commands Manual
gnunet-gns - Access to GNUnet Name Service
gnunet-gns can be used to lookup and process GNUnet Name Service names.
- -c FILENAME, --config=FILENAME
- Use the configuration file FILENAME.
- -r, --raw
- No unneeded output. This is a quiet mode where only important information
is displayed. For example a lookup for an IP address will only yield the
IP address, no descriptive text.
- -h, --help
- Print short help on options.
- -L LOGLEVEL, --loglevel=LOGLEVEL
- Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and
- -u NAME, --lookup=NAME
- Name to lookup. Resolve the specified name using the GNUnet Name
- -p PKEY, --public-key=PKEY
- Public key of the zone to perform the lookup in. This option should be
used if the lookup is to be performed against a zone not controlled by
this peer (alternatively, you could pass a ".zkey" for the
- -T DELAY, --timeout=DELAY
- Set the timeout to DELAY. By default, gnunet-gns will continue to try to
resolve the name until there is a definitive answer or until the user
aborts with CTRL-C.
- -t TYPE, --type=TYPE
- Resource Record Type (TYPE) to look for. Supported TYPE's are: A, AAAA,
CNAME, NS, PKEY, PSEU, TLSA, SRV, SOA, MX, LEHO, VPN, REV, PTR, TXT
Defaults to "A".
- -z NAME, --zone=NAME
- Name of the ego of the zone to lookup the record in. The public key
associated with the ego will be used for the zone.
- -v, --version
- Print GNUnet version number.