Scroll to navigation

VIRTIO_SCSI(4) Device Drivers Manual VIRTIO_SCSI(4)

NAME

virtio_scsi
VirtIO SCSI driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:
device virtio_scsi

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

virtio_scsi_load="YES"

DESCRIPTION

The virtio_scsi device driver provides support for VirtIO SCSI devices.

LOADER TUNABLES

Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5).
hw.vtscsi.bus_reset_disable
In the initial QEMU release with VirtIO SCSI support, in-flight operations were not aborted when stopping the device, rendering bus reset ineffective. This tunable disables attempts to issue reset bus commands. The default value is 1.

DEBUGGING

To enable debugging prints from the virtio_scsi driver, set the
hw.vtscsi.X.debug_level

variable, where X is the adapter number, either in loader.conf(5) or via sysctl(8). The following bits have the described effects:

0x01
Enable informational prints.
0x02
Enable prints for driver errors.
0x04
Enable tracing prints.

SEE ALSO

virtio(4)

HISTORY

The virtio_scsi driver was written by Bryan Venteicher <bryanv@FreeBSD.org>. It first appeared in FreeBSD 10.0.
June 24, 2012 Linux 4.19.0-10-amd64