Scroll to navigation

UBSA(4) Device Drivers Manual UBSA(4)

NAME

ubsa
USB support for Belkin serial adapters

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:
device usb
device ucom
device ubsa

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

ubsa_load="YES"

DESCRIPTION

The ubsa driver provides support for the USB-to-RS232 Bridge chip used by a variety of serial adapters from Belkin and other vendors.

The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

HARDWARE

The ubsa driver supports the following adapters:

  • AnyData ADU-500A EV-DO modem
  • AnyData ADU-E100A (no EV-DO mode support)
  • Belkin F5U103
  • Belkin F5U120
  • e-Tek Labs Kwik232
  • GoHubs GoCOM232
  • Peracom single port serial adapter

FILES

/dev/ttyU*
for callin ports
/dev/ttyU*.init
 
/dev/ttyU*.lock
corresponding callin initial-state and lock-state devices

/dev/cuaU*
for callout ports
/dev/cuaU*.init
 
/dev/cuaU*.lock
corresponding callout initial-state and lock-state devices

SEE ALSO

tty(4), ucom(4), usb(4)

HISTORY

The ubsa driver appeared in FreeBSD 5.0. The uplcom(4) manual page was adopted from NetBSD by Tom Rhodes <trhodes@FreeBSD.org> in April 2002 and modified for the ubsa driver by Alexander Kabaev <kan@FreeBSD.org> in October 2002.

AUTHORS

The ubsa driver was written by Alexander Kabaev <kan@FreeBSD.org>.
April 26, 2017 Linux 4.19.0-10-amd64