|git-annex-enableremote(1)||General Commands Manual||git-annex-enableremote(1)|
git-annex-enableremote - enables git-annex to use a remote
git annex enableremote name|uuid|desc [param=value ...]
Enables use of an existing remote in the current repository, that was set up earlier by git annex initremote run in another clone of the repository.
When enabling a remote, specify the same name used when originally setting up that remote with git annex initremote. Run git annex enableremote without any name to get a list of remote names. Or you can specify the uuid or description of the remote.
Some types of special remotes need parameters to be specified every time they are enabled. For example, the directory special remote requires a directory= parameter every time. The command will prompt for any required parameters you leave out.
This command can also be used to modify the configuration of an existing special remote, by specifying new values for parameters that are usually set when using initremote. (However, some settings such as the as the encryption scheme cannot be changed once a special remote has been created.)
The GPG keys that an encrypted special remote is encrypted with can be changed using the keyid+= and keyid-= parameters. These respectively add and remove keys from the list. However, note that removing a key does NOT necessarily prevent the key's owner from accessing data in the encrypted special remote (which is by design impossible, short of deleting the remote).
One use-case of keyid-= is to replace a revoked key with a new key:
git annex enableremote mys3 keyid-=revokedkey keyid+=newkey
Also, note that for encrypted special remotes using plain public-key encryption (encryption=pubkey), adding or removing a key has NO effect on files that have already been copied to the remote. Hence using keyid+= and keyid-= with such remotes should be used with care, and make little sense except in cases like the revoked key example above.
If you get tired of manually enabling a special remote in each new clone, you can pass "autoenable=true". Then when git-annex-init(1) is run in a new clone, it will will attempt to enable the special remote. Of course, this works best when the special remote does not need anything special to be done to get it enabled.
(This command also can be used to enable a git remote that git-annex has found didn't work before and gave up on using, setting remote.<name>.annex-ignore.)
Joey Hess <email@example.com>