|UKBD(4)||Device Drivers Manual||UKBD(4)|
ukbd — USB
To compile this driver into the kernel, place the following line in your kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
By default, the keyboard subsystem does not create the appropriate devices yet. Make sure you reconfigure your kernel with the following option in the kernel config file:
If both an AT keyboard USB keyboards are used at the same time, the AT keyboard will appear as kbd0 in /dev. The USB keyboards will be kbd1, kbd2, etc. You can see some information about the keyboard with the following command:
kbdcontrol -i < /dev/kbd1
or load a keymap with
kbdcontrol -l keymaps/pt.iso < /dev/kbd1
See kbdcontrol(1) for more possible options.
You can swap console keyboards by using the command
kbdcontrol -k /dev/kbd1
From this point on, the first USB keyboard will be the keyboard to be used by the console.
If you want to use a USB keyboard as your default and
not use an AT keyboard at all, you will have to remove the
device atkbd line from the kernel configuration
file. Because of the device initialization order, the USB keyboard will be
detected after the
console driver initializes itself and you have to explicitly tell the
console driver to use the existence of the USB keyboard. This can be done in
one of the following two ways.
Run the following command as a part of system initialization:
kbdcontrol -k /dev/kbd0 < /dev/ttyv0 > /dev/null
(Note that as the USB keyboard is the only keyboard, it is accessed as /dev/kbd0) or otherwise tell the console driver to periodically look for a keyboard by setting a flag in the kernel configuration file:
device sc0 at isa? flags 0x100
With the above flag, the console driver will try to detect any keyboard in the system if it did not detect one while it was initialized at boot time.
Make the keyboards available through a character device in /dev.
The above lines will put the French ISO keymap in the ukbd driver. You can specify any keymap in /usr/share/syscons/keymaps or /usr/share/vt/keymaps (depending on the console driver being used) with this option.
Do not allow the user to change the keymap. Note that these options also affect the AT keyboard driver, atkbd(4).
- Debug output level, where 0 is debugging disabled and larger values increase debug message verbosity. Default is 0.
- blocking device nodes
ukbd driver to the kernel.
|April 24, 2018||Debian|