table of contents
|AE(4)||Device Drivers Manual||AE(4)|
Attansic/Atheros L2 FastEthernet controller
To compile this driver into the kernel, place the following lines in your kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
ae device driver provides support for
Attansic/Atheros L2 PCIe FastEthernet controllers.
The controller supports hardware Ethernet checksum processing, hardware VLAN tag stripping/insertion and an interrupt moderation mechanism. Attansic L2 also features a 64-bit multicast hash filter.
ae driver supports the following media
- Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf(5).
- Select 10Mbps operation.
- Set 100Mbps (FastEthernet) operation.
ae driver provides support for the
following media options:
- Force full duplex operation.
- Force half duplex operation.
For more information on configuring this device, see ifconfig(8).
ae driver supports Attansic/Atheros L2
PCIe FastEthernet controllers, and is known to support the following
- ASUS EeePC 701
- ASUS EeePC 900
Other hardware may or may not work with this driver.
Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5).
- This tunable disables MSI support on the Ethernet hardware. The default value is 0.
ae driver collects a number of useful
MAC counter during the work. The statistics is available via the
dev.ae.%d.stats sysctl(8) tree,
where %d corresponds to the controller number.
- ae%d: watchdog timeout.
- The device has stopped responding to the network, or there is a problem with the network connection (cable).
- ae%d: reset timeout.
- The card reset operation has been timed out.
- ae%d: Generating random ethernet address.
- No valid Ethernet address was found in the controller NVRAM and registers. Random locally administered address with ASUS OUI identifier will be used instead.
altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), vlan(4), ifconfig(8)
ae driver and this manual page was
written by Stanislav Sedov
It first appeared in FreeBSD 7.1.
The Attansic L2 FastEthernet controller supports DMA but does not use a descriptor based transfer mechanism via scatter-gather DMA. Thus the data should be copied to/from the controller memory on each transmit/receive. Furthermore, a lot of data alignment restrictions apply. This may introduce a high CPU load on systems with heavy network activity. Luckily enough this should not be a problem on modern hardware as L2 does not support speeds faster than 100Mbps.
|May 17, 2019||Debian|