|rpl8(8)||System Manager's Manual||rpl8(8)|
rpl8 - Firmware loader for DVD drives
rpl8 /dev/cdrom [-[dump-only]|firmwarefile]
rpl8 is a program for Linux 2.4 and upwards that uploads firmware to DVD drives (mostly DVD+RW).
rpl8 stands for RICOH Program Loader 8, though it also supports Program Loader 9.
The program never updates Program Loader code so that you should always be able to downgrade your firmware in case something goes wrong.
So far rpl8 has been tested with the following:
* HP dvd100i
* Ricoh MP5120A
* Philips DVDRW208
* HP dvd200i
To run rpl8 correctly, make sure you have no media in drive. Optionally go to single user mode and reboot after uploading the new firmware.
- Only backs up the firmware. Note that you might have to reboot even after this.
Getting messages like this is "normal"
- ide-scsi: Strange, packet command initiated yet DRQ isn't asserted
rpl8 is in public domain.
This manual page was written by Elias Kunnas <email@example.com>, for the Debian project (but may be used by others).
|15 September 2005|